Cisco 1600 series - Page 6

Installation instruction
Siemens Remote Service COIT-000.812.04.02.02 Seite 6/14 Siemens AG
Rev. 02 02-02 CO SGK Medical Solutions
&RQQHFWLQJ&LVFRWRWKH/$1
One of the gray straight-through RJ-45-to-RJ-45 cables (contained in the package – do not use a
cable with the label „CAB-U-RJ45“) is necessary for this connection. Follow these steps to connect the
router to a 10BaseT Ethernet LAN (Figure 2):
6WHS Connect one end of the Ethernet cable to the 10BASE T port.
6WHS Connect the other end of the cable to one of the ports on the 10BaseT hub, switch or network
walljack.
6WHS Check the following LEDs:
• LNK LED (rear panel, next to 10BaseT port)---On if the router is connected
correctly to the 10BaseT Ethernet LAN.
• LAN ACT LED (front panel)---On while there is traffic on the Ethernet LAN.
)LJXUH
1RWH If you want to connect the router directly to a PC, Server, Workstation you will need a cross
over RJ-45-to-RJ-45 cable (QRWLQFOXGHGLQWKHSDFNDJH.