Appendix C Installing and Upgrading Router Memory
C-2
Cisco 1700 Router Hardware Installation Guide
78-5405-03
Opening the Chassis
In order to upgrade Cisco 1700 router memory, you must open the chassis.
Opening the chassis requires a number one Phillips screwdriver.
Follow these steps to open the chassis:
Step 1 Make sure the router is turned OFF and is disconnected
from the power supply.
Step 2 Turn the router upside down, and rest the top of the
router on a flat surface.
Step 3 Use the Phillips screwdriver to remove the four screws
that hold the top and bottom of the chassis together, as
shown in Figure C-1.
Step 4 Turn the router back to its original position (right-side
up).
To Next Page
Loading...
