Cisco 1900 series - Page 6

-vi
Cisco 1900 Series Hardware Installation
OL-19084-02
Chapter
Installing the Cisco Microsoft Windows XP USB Driver 5-6
Installing the Cisco Microsoft Windows 2000 USB Driver 5-7
Installing the Cisco Microsoft Windows Vista USB Driver 5-7
Uninstalling the Cisco USB Driver 5-8
Uninstalling the Cisco Microsoft Windows XP and 2000 USB Driver 5-8
Uninstalling the Cisco Microsoft Windows Vista USB Driver 5-8
Connecting to the Auxiliary Port 5-9
CHAPTER 6 Configuring the Router 6-1
Powering up the Router 6-1
Checklist for Power Up 6-1
Power Up Procedure 6-2
Verifying the Front Panel LED Indications 6-3
Performing the Initial Configuration on the Router 6-4
Using the Cisco Setup Command Facility 6-4
Completing the Configuration 6-7
Using Cisco Configuration Professional Express 6-8
Using the Cisco CLI—Manual Configuration 6-9
Configuring the Router Hostname 6-10
Configuring the Enable and Enable Secret Passwords 6-11
Configuring the Console Idle Privileged EXEC Timeout 6-12
Configuring Gigabit Ethernet Interfaces 6-14
Specifying a Default Route or Gateway of Last Resort 6-16
Configuring IP Routing and IP Protocols 6-16
Default Routes 6-16
Default Network 6-16
Gateway of Last Resort 6-17
Configuring Virtual Terminal Lines for Remote Console Access 6-19
Configuring the Auxiliary Line 6-20
Verifying Network Connectivity 6-22
Saving Your Router Configuration 6-23
Saving Backup Copies of Configuration and System Image 6-23
Verifying the Initial Configuration 6-25
CHAPTER 7 Getting Software Licenses for the Router 7-1
Activating a New Software Package or Feature 7-1
RMA License Transfer 7-2
Additional Information 7-3