Cisco 2500 Series Deployment Guide

In the WCS Interface, go to Configure > Controllers on the WCS interface. Choose Add Controller
from the drop−down box on the right−hand side, and click Go.
3.
Enter the IP Address of the Cisco 2500 Series Wireless Controller management interface, and
configure the appropriate SNMP parameters. Click OK.
The controller is added successfully, and the Cisco 2500 Series Wireless Controller is ready to be
provisioned by the WCS.
4.
In order to verify the Cisco 2500 Series Wireless Controller after it is added in WCS, go to Monitor >
Controllers to see the controller details.
Cisco 2500 Series Wireless Controller Deployment
Scenarios
Cisco 2500 Series Wireless Controller provides a cost effective unified wireless solution. Although the
controller has multiple 10/100/1000 ports, it does not behave like switches or routers. It is not recommended
to use different ports as a hub/switch implementation. Understanding this fundamental point is a key aspect of
getting the best performance out of the controller.

Cisco 2500 Series Specifications

General

Brand	Cisco
Model	2500 Series
Category	Controller
Language	English