Cisco 2500 Series Installing Guide

Installing Cisco AC and DC Power Supplies in Cisco 2500 Series Routers 11
Obtaining Service and Support
Figure 11 Rear Panel Label Locations
Note The System Identifier label shown in Figure 11 shows the Cisco 2520 DC system label for
demonstration purposes. Place the appropriate label for your specific model of Cisco 2500 series
router in place of this label.
Step 3 Remove the System Identifier label from the sheet of labels included with the power
supply. (See Figure 10)
Step 4 Place the System Identifier label directly to the left of the on/off power switch on the rear
panel of the Cisco 2500 series router. (See Figure 11)
Obtaining Service and Support
For service and support for a product purchased from a reseller, contact the reseller. Resellers offer
a wide variety of Cisco service and support programs, which are described in the section “Service
and Support” in the information packet that shipped with your chassis.
Note If you purchased your product from a reseller, you can access Cisco Connection Online
(CCO) as a guest. CCO is Cisco Systems’ primary, real-time support channel. Your reseller offers
programs that include direct access to CCO’s services.
For service and support for a product purchased directly from Cisco, use CCO.
Cisco Connection Online
CCO is Cisco Systems’ primary, real-time support channel. SMARTnet customers and partners can
self-register on CCO to obtain additional information and services.
Note If you purchased your product from a reseller, you can access CCO as a guest. Your reseller
offers programs that include direct access to CCO’s services.
H9688
0
1
System identifier
label
Power requirements
label
Cisco
2520 DC
Input 40 – 72 V
Current 1.5 – 1.0 A
Watts 40 W

Cisco 2500 Series Specifications

General

Brand	Cisco
Model	2500 Series
Category	Controller
Language	English