Cisco 2600 Series Hardware Installation Guide
ROM Monitor Syntax Conventions
C-4
ROM Monitor Syntax Conventions
The ROM monitor syntax in this appendix uses the following conventions:
• Square brackets [ ] denote an optional element. In the following example, the element
abc is not required, but you can specify it if you choose:
command [abc]
• If a minus option is followed by a colon (for example, [-s:]) you must provide an
argument for the option.
• A term in italics means that you must fill in the appropriate information. In the following
example, you replace the term in italics with the interface type you are using:
command type interface
Command Descriptions
This section lists some useful ROM monitor commands. Refer to the Cisco IOS
configuration guides and command references for more information on ROM monitor
commands.
• boot or b—Boot an image.
—bboots the first image in Flash memory.
—bflash:[name] boots the Cisco IOS software from the Flash memory.
—bfilename tftpserver boots from the specified file over the network from the
specified Trivial File Transfer Protocol (TFTP) server. For example:
boot c2600-i-mz 172.15.19.11
To Next Page
Loading...
