Cisco 2800 Series

Configuring Radio Settings on an Access Point
How to Configure Radio Settings on an Access Point
20
SUMMARY STEPS
1. enable
2. configure terminal
3. interface dot11Radio interface
4. payload-encapsulation {rfc1042 | dot1h}
5. end
6. copy running-config startup-config
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Enters radio interface configuration mode.
• The interface argument is in module/slot/port format,
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
• The 2.4-GHz radio is port 0, and the 5-GHz radio is
port 1.
Step 4
payload-encapsulation {rfc1042 | dot1h}
Example:
Router(config-if)# no dot11 extension aironet
Specifies the encapsulation transformation method to RFC
1042 (SNAP) or dot1h (IEEE 802.1h).
Step 5
end
Example:
Router(config-if)# end
Returns to privileged EXEC mode.
Step 6
copy running-config startup-config
Example:
Router# copy running-config startup-config
(Optional) Saves your entries in the configuration file.