EasyManua.ls Logo

Cisco 2010 User Manual

Cisco 2010
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Americas Headquarters
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
http://www.cisco.com
Tel: 408 526-4000
800 553-NETS (6387)
Fax: 408 527-0883
Cisco 2010 Connected Grid Router
Hardware Installation Guide
Text Part Number: OL-21559-01

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Cisco 2010 and is the answer not in the manual?

Cisco 2010 Specifications

General IconGeneral
Product TypeRouter
Form FactorDesktop
Connectivity TechnologyWired
Data Link ProtocolEthernet, Fast Ethernet
WAN Ports Qty1
VPN SupportYes
Routing ProtocolRIP-1, RIP-2
Remote Management ProtocolSNMP, Telnet
Featuresfirewall protection, DHCP support, NAT support, VPN support
Compliant StandardsIEEE 802.3, IEEE 802.3u

Summary

Overview of the Router

Chassis Views

Provides views of the power supply and cable side panels of the Cisco 2010 CGR.

Hardware Features

Describes the hardware features of the Cisco 2010 CGR, including ports and modules.

Slot, Port, and Interface Information

Details the numbering format for slots and ports on the Cisco 2010 CGR.

LED Indicators

Summarizes the LED indicators located on the router bezel or chassis.

Specifications

Provides details on the technical specifications of the Cisco 2010 CGR router.

Preparing for Router Installation

Safety Recommendations

Outlines general safety guidelines to follow during installation and operation.

General Site Requirements

Describes site preparation requirements for safe router installation and operation.

Power Guidelines and Requirements

Details requirements for clean power supply and AC/DC voltage considerations.

Required Tools and Equipment

Lists the necessary tools and equipment for router installation and maintenance.

Installing and Connecting the Router

Before You Begin

Covers safety warnings and tools needed before starting router installation.

Installing the Router in a Rack

Provides instructions on how to mount the Cisco 2010 CGR router in a standard rack.

Connecting Power

Explains the procedure for connecting AC or DC power to the Cisco 2010 CGR.

Connecting to a Console Terminal or Modem

Details how to establish administrative access via console or modem connection.

Configuring the Router

Powering up the Router

Guides on powering up the router and verifying its initialization and self-test.

Performing Initial Configuration

Explains how to perform the initial router configuration using CLI or other tools.

Verifying Initial Configuration

Details commands to verify the initial configuration and router status.

Installing and Upgrading Internal Modules

Safety Warnings

Lists critical safety warnings before performing module replacement or upgrades.

Replacing Power Supplies

Provides steps for replacing hot-swappable power supply units in the router.

Compact Flash Memory Card Operations

Covers procedures for removing and installing compact flash memory cards.

Installing SFP Modules

Explains how to install Small Form-factor Pluggable (SFP) modules for connectivity.

Related product manuals