Cisco 2010 - Installing and Connecting the Router

CHAPTER
3-1
Cisco Connected Grid Routers 2010 Hardware Installation Guide
OL-21559-01
3
Installing and Connecting the Router
This document describes how to install and connect Cisco Connected Grid Routers (CGR) 2010 to a
LAN or WAN. The following sections provide technical details.
• What you Need to Know, page 3-3
• Before You Begin, page 3-4
• Unpacking the Router, page 3-4
• Installing the Router in a Rack, page 3-4
• Connecting Power, page 3-7
• Connecting to a Console Terminal or Modem, page 3-10
• Installing the Cisco Microsoft Windows USB Device Driver, page 3-13
• Uninstalling the Cisco Microsoft Windows USB Driver, page 3-15
• Connecting to the Auxiliary Port, page 3-16
• Connecting WAN and LAN Interfaces, page 3-17
Note To see translations of the warnings that appear in this publication, see Cisco Connected Grid Routers
Series Regulatory Compliance and Safety Information.
Caution For the optimum temperature ranges, do not operate it in an area that less than the minimum of 40°C and
exceeds a maximum recommended ambient temperature of 60°C.
Note To view specifications for the 2010 CGR router, see the Cisco 2010 Connected Grid Router data sheet at:
http://www.cisco.com/en/US/prod/collateral/routers/ps10967/ps10977/data_sheet_c78_593509.html
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030