Cisco 2800 Series Configuring

Configuring Radio Settings on an Access Point
Configuration Examples for Radio Settings on an Access Point
27
DETAILED STEPS
Configuration Examples for Radio Settings on an Access Point
This section contains the following examples:
• Configuring Radio Data Rates: Example
Configuring Radio Data Rates: Example
The following example shows how to disable the 1-Mbps data rate and set the rest of the data rates to
basic:
configure terminal
interface dot11radio 0
no speed basic-2.0 basic-5.5 basic-11.0
end
copy running-config startup-config
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
dot11 phone
Example:
Router(config)# dot11 phone
Enables IEEE 802.11 compliance phone support.
Step 4
end
Example:
Router(config-if)# end
Returns to privileged EXEC mode.
Step 5
copy running-config startup-config
Example:
Router# copy running-config startup-config
(Optional) Saves your entries in the configuration file.

Cisco 2800 Series Specifications

General

Power Supply	Internal power supply
Product Type	Router
Form Factor	Rack-mountable
Connectivity Technology	Wired
Power Device	Internal power supply
Operating System	Cisco IOS
Integrated Services	Security, voice
WAN Interfaces	T1/E1, Serial
LAN Interfaces	Fast Ethernet, Gigabit Ethernet
Expansion Slots	4
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Network/Transport Protocol	IP, TCP
Remote Management Protocol	SNMP, Telnet
Features	VPN support, Quality of Service (QoS), VLAN support
Voltage Required	AC 100-240 V
Security Features	Firewall, VPN, Access Control Lists (ACLs)