Cisco 2800 Series Configuring

Configuring Radio Settings on an Access Point
How to Configure Radio Settings on an Access Point
4
• Configuring RTS Threshold and Retries on an Access Point, page 22 (optional)
• Configuring Maximum Data Retry on an Access Point, page 24 (optional)
• Configuring Packet Fragmentation Threshold on an Access Point, page 25 (optional)
• Configuring IP Phone Support on an Access Point, page 26 (optional)
Configuring Universal Client Mode
Perform this task to configure universal client mode.
You can configure universal client mode on a Cisco ISR series router by setting the radio interface station
role to nonroot. This is different from configuring the dot11radio interface to operate in non-root bridge
mode, which requires specifying the word bridge at the end of the command, for example, station-role
non-root bridge.
Note In other Cisco wireless products such as the Cisco AP1232, the station-role non-root command
operates the same as station-role non-root bridge command. On the ISRs, the two commands are
different: station-role non-root is considered the universal client mode and station-role non-root
bridge is considered the nonroot bridge mode.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface dot11Radio interface
4. station-role {root [access-point | ap-only | bridge [wireless-clients]] | non-root [bridge]}
5. end
6. copy running-config startup-config

Cisco 2800 Series Specifications

General

Power Supply	Internal power supply
Product Type	Router
Form Factor	Rack-mountable
Connectivity Technology	Wired
Power Device	Internal power supply
Operating System	Cisco IOS
Integrated Services	Security, voice
WAN Interfaces	T1/E1, Serial
LAN Interfaces	Fast Ethernet, Gigabit Ethernet
Expansion Slots	4
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Network/Transport Protocol	IP, TCP
Remote Management Protocol	SNMP, Telnet
Features	VPN support, Quality of Service (QoS), VLAN support
Voltage Required	AC 100-240 V
Security Features	Firewall, VPN, Access Control Lists (ACLs)