Cisco 2800 Series Configuring

Configuring Radio Settings on an Access Point
How to Configure Radio Settings on an Access Point
25
Configuring Packet Fragmentation Threshold on an Access Point
Perform this task to configure the size at which packets are fragmented (sent as several pieces instead of
as one block).
Use a low setting in areas where communication is poor or where there is a great deal of radio
interference.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface dot11Radio interface
4. fragment-threshold bytes
5. end
6. copy running-config startup-config

Cisco 2800 Series Specifications

General

Power Supply	Internal power supply
Product Type	Router
Form Factor	Rack-mountable
Connectivity Technology	Wired
Power Device	Internal power supply
Operating System	Cisco IOS
Integrated Services	Security, voice
WAN Interfaces	T1/E1, Serial
LAN Interfaces	Fast Ethernet, Gigabit Ethernet
Expansion Slots	4
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Network/Transport Protocol	IP, TCP
Remote Management Protocol	SNMP, Telnet
Features	VPN support, Quality of Service (QoS), VLAN support
Voltage Required	AC 100-240 V
Security Features	Firewall, VPN, Access Control Lists (ACLs)