CHAPTER
2-1
Catalyst 2960-S Switch Hardware Installation Guide
OL-19732-04
2
Switch Installation
Read these topics and perform the procedures in this order:
• Preparing, page 2-1
• Planning a Switch Stack, page 2-5
• Installing the Switch, page 2-10
• Connecting the FlexStack Cables, page 2-17
• Installing the Power Cord Retainer (Optional), page 2-18
• Installing SFP and SFP+ Modules, page 2-20
• Connecting to SFP and SFP+ Modules, page 2-22
• 10/100 and 10/100/1000 PoE+ Port Connections, page 2-24
• 10/100 and 10/100/1000 Port Connections, page 2-26
For initial switch setup, assigning the switch IP address, and powering on information, see the switch
getting started guide on Cisco.com.
Preparing
• Safety Warnings, page 2-1
• Installation Guidelines, page 2-4
• Box Contents, page 2-4
• Tools and Equipment, page 2-4
Safety Warnings
This section includes the basic installation caution and warning statements. Read this section before you
start the installation procedure. Translations of the warning statements appear in the Regulatory
Compliance and Safety Information for the Catalyst
2960 and 2960-S Switches guide on the
documentation CD and online at Cisco.com.
Warning
Do not stack the chassis on any other equipment. If the chassis falls, it can cause severe bodily injury
and equipment damage.
Statement 48
To Next Page
Loading...
