Cisco 2960-C - User Manual

CHAPTER
2-1
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
OL-23803-02
2
Switch Installation
This chapter describes how to start your switch and how to interpret the power-on self-test (POST) that
ensures proper operation. It also describes how to install the switch.
Read the topics and perform the procedures in this order:
• Preparing for Installation, page 2-1
• Verifying Switch Operation, page 2-5
• Mounting the Switch, page 2-5
• Installing a Cover for the Reset Button (Optional), page 2-24
• Installing the Power Cord Retainer (Optional), page 2-25
• Installing the Cable Guard (Optional), page 2-28
• Connecting Devices to the Ethernet Ports, page 2-33
Preparing for Installation
• Warnings, page 2-1
• Installation Guidelines, page 2-3
• Equipment That You Supply, page 2-4
• Box Contents, page 2-4
• Powering the Switch, page 2-4
Warnings
These warnings are translated into several languages in the Regulatory Compliance and Safety
Information for the Catalyst 3560-C and the 2960-C Switches guide.
Warning Before working on equipment that is connected to power lines, remove jewelry (including rings,
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals. Statement 43

Cisco 2960-C Specifications

General

Switching Capacity	16 Gbps
Forwarding Rate	6.5 Mpps
MAC Address Table Size	8, 000 entries
RAM	128 MB
Flash Memory	64 MB
Stacking	Not supported
Ports	8 x 10/100 Fast Ethernet
Uplink Interfaces	1 x dual-purpose (10/100/1000 or SFP)
PoE	No PoE
Storage Temperature	-20°C to 65°C
Relative Humidity	10% to 85% non-condensing
Operating Temperature	32°F to 113°F (0°C to 45°C)

Summary

Switch Installation

Preparing for Installation

Steps for preparing the switch, including safety and equipment checks before installation.

Verifying Switch Operation

Process for confirming the switch's functionality after power-on and POST.

Mounting the Switch

Procedures for physically installing the switch in various locations like desks, racks, or walls.

Installing a Cover for the Reset Button (Optional)

Instructions to install an optional cover to prevent accidental reset of the switch.

Installing the Power Cord Retainer (Optional)

Steps for installing an optional retainer to secure the power cord to the switch.

Installing the Cable Guard (Optional)

Guide for installing an optional cable guard for enhanced cable management and security.

Connecting Devices to the Ethernet Ports

Instructions for connecting network devices to the switch's Ethernet ports.