Cisco 2960-S - Page 4

Contents
iv
Catalyst 2960-S Switch Hardware Installation Guide
OL-19732-04
Box Contents 2-4
Tools and Equipment 2-4
Verifying Switch Operation 2-5
Planning a Switch Stack 2-5
Stack Guidelines 2-5
Installing the FlexStack Module 2-7
Stack Cabling 2-8
Stack Bandwidth and Partitioning Examples 2-8
Power-On Sequence for Switch Stacks 2-10
Installing the Switch 2-10
Rack-Mounting 2-10
Attaching the Rack-Mount Brackets 2-11
Mounting in a Rack 2-13
Wall-Mounting 2-14
Attaching the Brackets for Wall-Mounting 2-14
Attaching the RPS Connector Cover 2-15
Mounting on a Wall 2-16
Table- or Shelf-Mounting 2-17
After Switch Installation 2-17
Connecting the FlexStack Cables 2-17
Installing the Power Cord Retainer (Optional) 2-18
Installing SFP and SFP+ Modules 2-20
Installing an SFP or SFP+ Module 2-21
Removing an SFP or SFP+ Module 2-21
Connecting to SFP and SFP+ Modules 2-22
Connecting to Fiber-Optic SFP and SFP+ Modules 2-22
Connecting to 1000BASE-T SFP 2-23
10/100 and 10/100/1000 PoE+ Port Connections 2-24
10/100 and 10/100/1000 Port Connections 2-26
Where to Go Next 2-26
CHAPTER 3 Troubleshooting 3-1
Diagnosing Problems 3-1
Switch POST Results 3-1
Switch LEDs 3-1
Switch Connections 3-2
Bad or Damaged Cable 3-2
Ethernet and Fiber-Optic Cables 3-2