Cisco 2960-S - Page 80

To Next Page

To Previous Page

B-8

Catalyst 2960-S Switch Hardware Installation Guide

OL-19732-04

Appendix B Connector and Cable Specifications

Cables and Adapters

Main Page

Default Chapter3
- Table of Contents3
Preface7
- Related Publications8
- Obtaining Documentation and Submitting a Service Request8
Chapter 1 Product Overview9
- Switch Models9
- Front Panel10
- Rear Panel25
- Management Options28
  - Network Configurations29
- Switch Installation31
Chapter 2 Switch Installation32
- Installation Guidelines34
Preparing34
- Verifying Switch Operation35
Planning a Switch Stack35
- Stack Guidelines35
- Installing the Flexstack Module37
- Stack Cabling38
- Stack Bandwidth and Partitioning Examples38
- Power-On Sequence for Switch Stacks40
Installing the Switch40
- Rack-Mounting40
  - Attaching the Rack-Mount Brackets41
  - Mounting in a Rack43
- Wall-Mounting44
- Table- or Shelf-Mounting47
- After Switch Installation47
Connecting the Flexstack Cables47
Installing the Power Cord Retainer (Optional)48
Installing SFP and SFP+ Modules50
- Installing an SFP or SFP+ Module51
- Removing an SFP or SFP+ Module51
Connecting to SFP and SFP+ Modules52
- Connecting to Fiber-Optic SFP and SFP+ Modules52
- Connecting to 1000BASE-T SFP53
10/100 and 10/100/1000 Poe+ Port Connections54
10/100 and 10/100/1000 Port Connections56
- Where to Go Next56
Chapter 3 Troubleshooting57
- Diagnosing Problems57
Appendix67
Technical Specifications67
Appendix A Technical Specification69
Appendix73
Connector and Cable Specifications73
- Connector Specifications73
- Cables and Adapters75
Appendix81
Configuring the Switch with the CLI-Based Setup Program81
- Accessing the CLI through Express Setup81
- Accessing the CLI through the Console Port81
- Entering the Initial Configuration Information86
  - IP Settings86
  - Completing the Setup Program86

Cisco 2960-S - Page 80

Table of Contents

Related product manuals