Cisco 3105 - Page 30

Statement 1057—Hazardous Radiation Exposure
Use of controls, adjustments, or performance of procedures other than those specified may result in
hazardous radiation exposure.
Warning
Use appropriate ESD procedures when inserting the transceiver. Avoid touching the contacts at the rear, and
keep the contacts and ports free of dust and dirt. Keep unused transceivers in the ESD packing that they were
shipped in.
Warning
Although non-Cisco SFPs are allowed, we do not recommend using them because they have not been tested
and validated by Cisco. Cisco TAC may refuse support for any interoperability problems that result from
using an untested third-party SFP transceiver.
Caution
The following table lists the supported transceivers for the fixed ports on all 3100 models, and the
FPR3K-XNM-8X10G and FPR3K-XNM-8X25G network modules.
Table 4: Supported 1-Gb SFP Transceivers
CommentsPIDOptics Type
1 Gb-copper SFPGLC-TE1G, 1000Base-T
850 nmGLC-SX-MMD1G multimode
1310 nmGLC-LH-SMD1G single mode
40 kmGLC-EX-SMD1G SM extended r.
80 kmGLC-ZX-SMD1G SM
The following table lists the supported transceivers for the fixed ports on all 3100 models and the
FPR3K-XNM-8X10G and FPR3K-XNM-8X25G network modules.
Table 5: Supported 10-Gb SFP Transceivers
CommentsPIDOptics Type
—SFP-10G-SR10G-SR
Ethernet onlySFP-10G-SR-S10G-SR
—SFP-10G-LR10G-LR
Ethernet onlySFP-10G-LR-S10G-LR
—SFP-10G-ER-S10G-ER
—SFP-10G-ZR10G-ZR
Overview
30
Overview
Supported SFP/SFP+/QSFP+ Transceivers