Cisco 3200 Series - Page 34

2-18
Cisco 3200 Series Router Hardware Upgrade Guide
OL-15983-01
Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure
Card Replacement Process
Note If a protective end cap cover is used to provide weatherproof protection for the ports on the I/O
end cap, align the holes of the hinge brackets of the protective end cap to the I/O end cap with
the holes of the mounting bolts on the I/O end cap. Then, insert the (4) mounting bolts through
the hinge bracket and I/O end cap holes to attach the I/O end cap and its protective cover to the
extrusion. Figure 2-16 shows the parts of a protective end cap cover.
Figure 2-16 Cisco 3200 Rugged Enclosure Protective End Cap Cover
1 Hinge point 2 NEC cable pass-through
3 Holes for 8/32-inch-long protective end
cap cover screws
4 Hinge/mounting bracket
5 Mounting bolt
158086
3
1
4
5
2
Get user manuals: See SafeManuals.com