Cisco 3945 User Manual

11
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Overview of the Hardware and Software
IOS Commands
Reloading the
router.
reload This command
reloads the router.
The reload time is
written to NV
memory.
Router#reload Potential enough to flap bfd.
Enabling warm
rebooting.
warm-reboot
count value
uptime value
Enables a router to
warm-reboot.
Router(config)#
warm-reboot
count 10 uptime
10
Potential enough to flap bfd.
New software
license boot.
license boot
module
module-name
level license-level
To boot a new
software license
on routing
platforms, use the
license boot
module command
in global
configuration
mode.
Router(config)#
license boot
module c2900
technology-packa
ge datak9
Potential enough to flap bfd.
Enabling or
disabling USB
ports.
config mode :
hw-module usb
Enable or disable
USB ports from
IOS config mode.
Router(config)#hw
-module usb
disable
Router(config)#no
hw-module usb
disable
Will trigger a BFD flap.
Disabling access
to ROMMON.
[no] service
password-recove
ry
This command
disables all access
to ROMMON.
Router# no service
password-recover
y
Potential enough to flap bfd.
Table 7 Cisco IOS Commands
Functionality Command Name Description
Configuration
Example Impact

Cisco 3945 Specifications

General

Form Factor	Rack-mountable
Maximum Throughput	75 Mbps
Product Type	Router
Connectivity Technology	Wired
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Operating System	Cisco IOS
Flash Memory	256 MB
Network/Transport Protocol	IPSec
Remote Management Protocol	SNMP
Encryption Algorithm	DES, AES
Features	Firewall, VPN, Quality of Service (QoS), VLAN support
Interfaces	2 x USB
Security Features	Intrusion Prevention System (IPS)
Operating Temperature	32 °F to 104 °F (0 °C to 40 °C)
Storage Temperature	-4 °F to 149 °F (-20 °C to 65 °C)
Humidity	10 - 85% (non-condensing)
Memory	2 GB
Expansion Slots	4 (free) x EHWIC ¦ 2 x service module ¦ 1 x ISM ¦ 1 x CompactFlash Card