EasyManuals Logo

Cisco 3945 User Manual

Cisco 3945
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #353 background imageLoading...
Page #353 background image
A-7
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Appendix A Cisco IOS CLI for Initial Configuration
Using the Cisco IOS CLI to Perform Initial Configuration
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
Enter your password if prompted.
Step 2
show ip interface brief
Example:
Router# show ip interface brief
Displays a brief status of the interfaces that are configured
for IP.
Learn which type of Ethernet interface is on your
router.
Step 3
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 4
interface gigabitethernet 0/port
Example:
Router(config)# interface gigabitethernet 0/0
Specifies the gigabit Ethernet interface and enters interface
configuration mode.
Note For information on interface numbering, see
Software Configuration Guide.
Step 5
description string
Example:
Router(config-if)# description GE int to 2nd
floor south wing
(Optional) Adds a description to an interface configuration.
The description helps you remember what is attached to
this interface. The description can be useful for
troubleshooting.
Step 6
ip address ip-address mask
Example:
Router(config-if)# ip address 172.16.74.3
255.255.255.0
Sets a primary IP address for an interface.
Step 7
no shutdown
Example:
Router(config-if)# no shutdown
Enables an interface.
Step 8
end
Example:
Router(config)# end
Returns to privileged EXEC mode.
Step 9
show ip interface brief
Example:
Router# show ip interface brief
Displays a brief status of the interfaces that are configured
for IP.
Verify that the Ethernet interfaces are up and
configured correctly.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3945 and is the answer not in the manual?

Cisco 3945 Specifications

General IconGeneral
Form FactorRack-mountable
Maximum Throughput75 Mbps
Product TypeRouter
Connectivity TechnologyWired
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Operating SystemCisco IOS
Flash Memory256 MB
Network/Transport ProtocolIPSec
Remote Management ProtocolSNMP
Encryption AlgorithmDES, AES
FeaturesFirewall, VPN, Quality of Service (QoS), VLAN support
Interfaces2 x USB
Security FeaturesIntrusion Prevention System (IPS)
Operating Temperature32 °F to 104 °F (0 °C to 40 °C)
Storage Temperature-4 °F to 149 °F (-20 °C to 65 °C)
Humidity10 - 85% (non-condensing)
Memory2 GB
Expansion Slots4 (free) x EHWIC ¦ 2 x service module ¦ 1 x ISM ¦ 1 x CompactFlash Card

Related product manuals