Cisco 575 LRE CPE - Page 31

2-7
Cisco 575 LRE CPE Hardware Installation Guide
78-11469-01
Chapter 2 Installation
Installing the CPE Under a Desk
Figure 2-1 Installing the Mounting Screws Under a Desk
Step 4
Peel the adhesive strip off the bottom of the screw template, and attach it to the
underside of the desk.
Step 5 Use a 1/44-inch bit to drill a 1/2-inch-deep hole in the two screw template slots.
Step 6 (Optional) If you wish to attach the cable lock after the cables are installed, drill
a 1/2-inch-deep hole in the cable lock hole. For more information, see the
“Attaching the Cable Lock” sectiononpage2-16.
Step 7 Insert two screws in the slots on the screw template, and tighten until they touch
the top of the screw template.
Step 8 Remove the screw template from underneath the desk.
Step 9 Slide the CPE onto the mounting screws until it locks in place. (See Figure 2-2.)
3 in.
(7.6 cm)
Desktop
Screw template
Wall
Screw
Cable
lock hole
Adhesive
47502
at least
1/2 in.
(12.7 mm)
Screw