Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Copyright © 1999. Cisco Systems, Inc. All rights reserved.
Cisco 700 Series Router Cabling and Setup
Quick Start Guide
This document describes the basic process of cabling and configuring the Internet access device, the
Cisco 700 series router. For advanced cabling information, refer to the Cisco 700 Series Router
Installation Guide. For advanced configuration information, refer to the Cisco 700 Series Router
Command Reference and the Cisco 700 Series Router Software Configuration Guide. These documents can
be found on the Cisco Documentation CD-ROM and Cisco Connection Online (CCO).
Parts List
• One Cisco 700 series router
• One yellow Ethernet cable
• One red ISDN U cable (Cisco 776 routers only)
• One orange ISDN S/T cable (Cisco 761 and 775 routers only)
• One RJ-45-to-RJ-11 adapter
• One blue config cable
• One black power supply
• One black power supply cord
• One Cisco Fast Step CD-ROM
Note Additional parts might be required to install Cisco775 and Cisco 776 routers. An Ethernet
crossover cable must be used to connect a hub to the router. Depending on the country, you
might need a phone port adapter to connect an analog telephone. These parts must be
provided by the user.
To Next Page
Need help?
General
