Cisco 7000 Series - Page 280

Index 6 Cisco 7010 Hardware Installation and Maintenance
copying files 3-31
loading microcode from 5-12
write-protection 5-17
frequency, specifications 1-5
FRUs
ACS-7010CBLM= cable management kit 5-71
ACS-7010RMK= rack mount kit 5-71
CHAS-7010= chassis with power supply 5-71
definition 1-1
descriptions 1-6
internal, replacing 5-70
locations of 1-6
MAS-7010= chassis (without power supply) 5-71
MAS-7010FAN= fan tray 5-70
MAS-7KARB= arbiter 5-70
MAS7K-BLANK interface processor filler 5-6
PKG-7010= spare shipping container and materials 5-71
PWR-7010AC*= power supply 5-71
FSIP
cables 1-30, 2-19
configuration 5-47
connectors 2-38
description 1-28
interface pinouts A-6
LEDs B-8
microcode ROM replacement 5-11
modes and timing 1-29, 2-40
modules 1-28
network connections (illustration) 3-22
NRZI format 2-39
PLCC microcode ROM, replacing 5-9
port adapters, replacing 5-51
speed 1-21
SRAM 1-28
troubleshooting 4-8
G
gravity, maintaining low center 2-14
ground screw 1-7
guides, backplane slot keys 1-10
H
Hall Effect signal 1-45
Halt LED on RP 1-15
handles
IPs 2-3, 5-7
power supply 1-7, 5-79
hardware address 1-35
heat dissipation 1-5
High-Level Data Link Control (HDLC) 2-19
high-speed serial interface processor
See HIP
HIP
cable pinouts A-12
connectors 2-43
description 1-21
LEDs B-10
microcode ROM replacement 5-11
network connections (illustration) 3-24
null modem cable pinouts A-13
See also HSSI
speeds rates 1-32
troubleshooting 4-8
HSSI
cable pinouts A-12
connectors 2-43
interface processor
See HIP
LEDs B-10
network connections (illustration) 3-24
null modem cable pinouts A-13
null modem connections 3-24
transmission distances 2-13
hssi internal-clock command 3-24
HSSI standard 2-13
humidity, specifications 1-5
I
i command (initialize and reboot) 5-23
IBM
and NRZI format on serial interfaces 2-40, 5-48
Spyglass chipset on TRIP 1-34
Token Ring network, description 2-29
IEEE
802.3u 2-6
IEEE 802.3
and EIP 1-25, 2-18
and Ethernet Version 2 2-24
description 2-24
physical layers 2-24
IEEE 802.5
and TRIP 2-8, 2-18, 2-29
specification 2-29
IEEE RS-232C standard 2-9
images, downloading 1-14, 5-9
immunity, agency approvals for interference 1-5
In Ring LED on TRIP
See LEDs
inlet air 1-45
installation checklist 2-48
interface
addresses 1-35
configuration 4-1