EasyManuals Logo

Cisco 802 User Manual

Cisco 802
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
Installing and Configuring Cisco 802 IDSL and Cisco 804 IDSL Routers
78-10368-03
Example of Frame Relay Configuration Output
Step 15 Specify a DLCI number that is used to connect to the Internet service provider. For example:
router(config)# frame-relay interface dlci 16 ieft
Step 16 End configuration mode.
router(config)# end
router#
Step 17 In user mode, set global NAT commands. In the following example, all inside network addresses
assigned to interface BRI0 are configured for translation, and the access list that contains the inside
network addresses is defined.
router# ip nat inside source list 1 interface bri0 overload
router# access-list 1 permit 192.168.1.0 0.0.0.255
Step 18 Save your configuration.
router# copy running-config startup-config
Example of Frame Relay Configuration Output
Current configuration:
!
!
version 12.0
service timestamps debug uptime
service timestamps log uptime
!
hostname c802idsl
username isp password 0 cisco
!
!
ip subnet-zero
!
isdn switch-type basic-5ess
isdn leased-line BRI0 144
isdn leased-line BRI0.1 144
!
!
interface Ethernet0
ip address 192.168.2.1 255.255.255.0
ip nat inside
!
interface BRI0
no ip address
encapsulation frame-relay IETF
frame-relay lmi-type ansi
!
interface BRI0.1 point-to-point
ip address 209.188.2.2 255.255.255.0
frame-relay interface-dlci 16 IETF
ip nat outside
!
ip nat inside source list 1 interface bri0:1 overload
access-list 1 permit 192.168.2.0 0.0.0.255

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 802 and is the answer not in the manual?

Cisco 802 Specifications

General IconGeneral
BrandCisco
Model802
CategoryNetwork Router
LanguageEnglish

Related product manuals