Cisco 8201

Replace Chassis Components
• Replace Fan Modules for Cisco 8201 Routers, on page 1
• Replace Power Supply, on page 3
Replace Fan Modules for Cisco 8201 Routers
The fan module is designed to be removed and replaced while the system is operating without presenting an
electrical hazard or damage to the system. Please keep the replacement fan modules ready prior to attempting
this task.
The routers support FAN-1RU-PI (port-side intake airflow) and FAN-1RU-PE (port-side exhaust airflow)
fan modules.
Note
The airflow direction must be the same for all power supply and fan modules in the chassis.
Note
Step 1 To remove a fan module, follow these steps:
a) Press two latches on the fan module and grasp the handle of fan module.
Replace Chassis Components
1

Cisco 8201 Specifications

General

Brand	Cisco
Model	8201
Category	Network Router
Language	English

Summary

Replace Fan Modules for Cisco 8201 Routers

Step 1: Remove Fan Module

Press two latches on the fan module and grasp the handle of fan module.

Step 2: Install Fan Module

Press latches to pull the fan module fully out of the chassis. Align and insert the new fan module until latches click.

Replace Power Supply

Remove Power Supply

Shut off circuit breaker, disconnect cable, unlatch and pull PSU from chassis.

Install Power Supply

Insert new PSU, connect cable, and verify power using command.