Configuring the Satellite Network Virtualization (nV) System on the Cisco ASR 9000 Series Router
Upgrading and Managing Satellite nV Software
HC-723
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide
OL-26061-03
Note For the satellite image upgrade to work, you must ensure that the management-plane CLI is not
configured on the Cisco ASR 9000 Series Router. If it is configured, then you need to add this exception
for each of the 10GigE interfaces, which are the satellite ICLs.
You can include the exception using this CLI:
control-plane
management-plane
inband
!
!
interface TenGigE0/0/0/5 <=== To enable TFTP on nV satellite ICL
allow TFTP
If you do not include this exception, then the image download and upgrade fails.
Monitoring the Satellite Software
• To perform a basic status check, use the show nv satellite status brief command.
RP/0/RSP0/CPU0:shanghai# show nv satellite status brief
Sat-ID Type IP Address MAC address State
------ -------- ------------ -------------- --------------------------------
100 asr9000v 101.102.103.105 dc7b.9426.1594 Connected (Stable)
200 asr9000v 101.102.103.106 0000.0000.0000 Halted; Conflict: no links configured
400 194.168.9.9 0000.0000.0000 Halted; Conflict: satellite has no type
configured
• To check if an upgrade is required on satellite, run the show nv satellite status satellite satellite_id.
Example
RP/0/RSP0/CPU0:sat-host#show nv satellite status satellite 100
Satellite 100
-------------
State: Connected (Stable)
Type: asr9000v
Description: sat-test
MAC address: dc7b.9427.47e4
IPv4 address: 100.1.1.1
Configured Serial Number: CAT1521B1BB
Received Serial Number: CAT1521B1BB
Remote version: Compatible (latest version)
ROMMON: 125.0 (Latest)
FPGA: 1.13 (Latest)
IOS: 200.8 (Latest)
Configured satellite fabric links:
TenGigE0/2/0/6
--------------
State: Satellite Ready
Port range: GigabitEthernet0/0/0-9
TenGigE0/2/0/13
---------------
State: Satellite Ready
Port range: GigabitEthernet0/0/30-39