To Next PageTo Next Page
How to fix lower ROM Monitor version detected on Cisco A9K-SIP-700?
If a lower version of the ROM Monitor is detected during system boot of your Cisco Network Router, use the "upgrade hw-module fpd" CLI in admin mode.
What to do if ROMMON B upgrade fails on Cisco Network Router?
If the version does not change after upgrading ROMMON B on your Cisco Network Router, it means the router loaded ROMMON A because it couldn't load ROMMON B. To fix this, upgrade the potentially corrupt image B using the "upgrade hw-module fpd" CLI in admin mode.
What to do if both ROMMON A and B are damaged in Cisco Network Router?
If both ROMMON A and ROMMON B are damaged on your Cisco Network Router due to an unexpected node reset or a power interruption during the upgrade, the affected route processors must be returned to Cisco for repair.
How to fix Cisco A9K-SIP-700 node upgrade failure?
If the node of your Cisco Network Router cannot be upgraded successfully, try reformatting the bootflash (format bootflash: [location all | node-id]) and then repeat this upgrade procedure.
General| Compatibility | Cisco ASR 9000 Series Routers |
|---|---|
| Form Factor | Plug-in Module |
| Interface Type | 10 Gigabit Ethernet |
| Hot Swappable | Yes |
| Product Series | ASR 9000 |
| Interfaces/Ports | 10 Gigabit Ethernet |
