periodic transmit
To send periodic Multiple VLAN Registration Protocol Data Unit (MVRPDU) on all active ports, use the
periodic transmit command in the MVRP configuration mode. To return to the default value, use the no
form of this command.
periodic transmit [interval interval]
no periodic transmit [interval interval]
Syntax Description
Sends periodic MVRPDU on all active ports at specified time interval. The
range is from 2 to 10 seconds.
interval interval
Command Default
The default is 3 seconds.
Command Modes
MVRP configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Sending periodic messages is not required when the state machines operate correctly. The periodic messages
are intended purely to cope with a succession of lost new declaration MVRPDUs. In the absence of periodic
messages, declarations are re-sent every 10 to 15 seconds in response to the LeaveAll timer expiring.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to enable MVRP static mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# spanning-tree mst AA
RP/0/RSP0/CPU0:router(config-mstp)# mvrp static
RP/0/RSP0/CPU0:router(config-mvrp)# periodic transmit interval 5
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
552
Multiple Spanning Tree Protocol Commands
periodic transmit
To Next Page
Loading...
Need help?
General
