interface (EVPN)
To enter the physical port interface or the bundle name interface configuration mode, use the interface
command in the EVPN configuration mode. To return to the EVPN configuration mode, use the no form of
this command.
interface type interface path-id
no interface type interface path-id
Syntax Description
Specifies the physical ethernet interface or bundle
ethernet Interface type connected to the CE device.
For more information about the syntax for the router,
use the question mark (?) online help function.
type
Physical port name or main bundle name.
The range for the bundle name is from 1 to 65535.
Use the show interfaces command to see a
list of all interfaces currently configured on
the router.
Note
For more information about the syntax for the router,
use the question mark (?) online help function.
interface path-id
Command Default
None.
Command Modes
EVPN configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
To specify a physical interface, the notation for the interface-path-id is rack/slot/module/port. The slash
between values is required as part of the notation. An explanation of each component of the naming notation
is as follows:
•
rack: Chassis number of the rack.
•
slot: Physical slot number of the line card.
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
410
Provider Backbone Bridge Commands
interface (EVPN)
To Next Page
Loading...
Need help?
General
