load-balancing-mode
To set the load balancing mode of a physical port or bundle to active-active, use the load-balancing-mode
command in the EVPN Interface Ethernet segment configuration mode. To disable the load balancing mode
from active-active, use the no form of this command.
load-balancing-mode per-service
no load-balancing-mode per-service
Syntax Description
Specifies the per-service load balancing.per-service
Command Default
Active-active per-flow
Command Modes
EVPN interface Ethernet segment configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use this command in a multi-homing configuration to set the redundancy mode to active-active per service.
In this mode, services that are active on one PoA are not active on the other PoA. Services can be represented
by an ISID in case of PBB EVPN.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to set the load balancing mode of a physical port or bundle to active-active:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# interface bundle-ether 1
RP/0/RSP0/CPU0:router(config-evpn-ac)# ethernet segment
RP/0/RSP0/CPU0:router(config-evpn-ac-es)# load-balancing-mode per-service
RP/0/RSP0/CPU0:router(config-evpn-ac-es)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
415
Provider Backbone Bridge Commands
load-balancing-mode
To Next Page
Loading...
Need help?
General
