timers
To configure timers that affect the convergence of PBB EVPN in failure scenarios, use the timers command
in the EVPN interface configuration or in the EVPN configuration mode. To delete the timer configuration,
use the no form of this command.
timers [flushagain | recovery | peering | programming]
no timers [flushagain | recovery | peering | programming]
Syntax Description
Specifies the MAC flush again timer.flushagain
Specifies the recovery timer.recovery
Specifies the peering timer.peering
Specifies the programming timer.programming
Command Default
None.
Command Modes
EVPN interface configuration
EVPN configuration
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The timers are configured globally in the EVPN configuration mode whereas in the EVPN interface
configuration mode, the timers are configured per Ethernet.
The keywords peering and programming are supported only in the EVPN configuration mode.
Task ID
OperationTask ID
read, writel2vpn
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
458
Provider Backbone Bridge Commands
timers
To Next Page
Loading...
Need help?
General
