pbb
To configure the provider backbone bridge core or edge, use the pbb command in the bridge domain
configuration submode. To return to the default behavior, use the no form of this command.
pbb {edge i-sid service-id core-bridge core-bridge-domain-name| core}
no pbb {edge i-sid service-id core-bridge core-bridge-domain-name| core}
Syntax Description
Configures the PBB edge.edge
Specifies the service instance identifier. The ranges is from 256 to
16777214.
The 16777215 (0xFFFFFF) service instance identifier is reserved
for wildcard.
Note
i-sid
Service instance identifier.
service-id
Specifies the name of the core-bridge domain connected to that edge-bridge
domain.
core-bridge
Core bridge domain name.
core-bridge-domain-name
Configures the PBB core.core
Command Default
None
Command Modes
L2VPN bridge group bridge domain configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command allows you to enter pbb edge configuration mode or pbb core configuration mode.
Task ID
OperationsTask ID
read, writel2vpn
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
420
Provider Backbone Bridge Commands
pbb
To Next Page
Loading...
Need help?
General
