name (MSTP)
To set the name of the MSTP region, use the name command in MSTP configuration submode.
name name
Syntax Description
String of a maximum of 32 characters conforming to the definition of
SnmpAdminString in RFC 2271.
name
Command Default
The MAC address of the switch, formatted as a text string using the hexadecimal representation specified in
IEEE Std 802.
Command Modes
MSTP configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeinterface
Examples
The following example shows how to set the name of the MSTP region to m1:
RP/0/RSP0/CPU0:router(config-mstp)# name m1
Related Commands
DescriptionCommand
Enables debugging for sent and received MSTP packets.debug spanning-tree mst packet, on page 479
Enables debugging protocol-state changes such as port role
or state changes, topology change notification.
debug spanning-tree mst protocol-state, on
page 481
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
550
Multiple Spanning Tree Protocol Commands
name (MSTP)
To Next Page
Loading...
Need help?
General
