logging nsr
To enable non-stop routing logging, use the logging nsr command in L2VPN configuration submode. To
return to the default behavior, use the no form of this command.
logging nsr
no logging nsr
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
L2VPN configuration submode
Command History
ModificationRelease
This command was introduced.Release 4.3.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
All L2VPN configuration can be deleted using the no l2vpn command.Note
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to enable non-stop routing logging:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# logging nsr
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
108
Point to Point Layer 2 Services Commands
logging nsr
To Next Page
Loading...
Need help?
General
