mac (VPLS)
To enter L2VPN bridge group bridge domain MAC configuration mode, use the mac command in L2VPN
bridge group bridge domain configuration mode. To disable all configurations added under the MAC
configuration submodes, use the no form of this command.
mac
no mac
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
L2VPN bridge group bridge domain configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the mac command to enter L2VPN bridge group bridge domain MAC configuration mode.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to enter L2VPN bridge group bridge domain MAC configuration mode:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# mac
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
277
Multipoint Layer 2 Services Commands
mac (VPLS)
To Next Page
Loading...
Need help?
General
