forward-delay (PVRST)
To set the forward-delay time for the bridge, use the forward-delay command in PVRST configuration
submode. To undo the setting, use the no form of this command.
forward-delay seconds
no forward-delay seconds
Syntax Description
Bridge forward delay time in seconds. The range is from 4 to 30.
seconds
Command Default
None
Command Modes
PVRST configuration
Command History
ModificationRelease
This command was introduced.Release 5.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
This example shows how to set the forward-delay parameter for the bridge to 20:
RP/0/RSP0/CPU0:router(config)# spanning-tree pvrst st1
RP/0/RSP0/CPU0:router(config-pvrst)# forward-delay 20
Related Commands
DescriptionCommand
Enables and configures Per VLAN Rapid Spanning Tree
(PVRST) on an interface.
interface (PVRST), on page 527
Sets the maximum age for the bridge.maximum (PVRST), on page 541
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
505
Multiple Spanning Tree Protocol Commands
forward-delay (PVRST)
To Next Page
Loading...
Need help?
General
