flood-time
To enable flooding of traffic to the entire core bridge when the PBB-VPLS Flood Optimization feature is
enabled on the core bridge, use the flood-time command in the flood optimization for PBB over VPLS global
configuration submode.
flood-time seconds
Syntax Description
Specifies the flood-time in seconds. Range is from 3 to 600 seconds.
seconds
Command Default
Flooding is disabled during convergence events.
Command Modes
Flood optimization for PBB over VPLS global configuration submode.
Command History
ModificationRelease
This command was introduced.Release 5.1.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Enables flooding of traffic on the entire core bridge when flood-time is enabled on the core bridge. This
provides time for MMRP to converge with the affected peer(s) before pruning the traffic. Flooding will be
disabled and the core bridge will start pruning the traffic when the flood-time has expired.
Task ID
OperationTask ID
read, writeethernet-services
Examples
The following example shows how to set the flood-time:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# mmrp-flood-optimization
RP/0/RSP0/CPU0:router(config-mmrp-flood-opt)# flood-time 80
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
406
Provider Backbone Bridge Commands
flood-time
To Next Page
Loading...
Need help?
General
