show mmrp-flood-optimization
To display the MMRP flood optimization information, use the show mmrp-flood-optimization command
in the EXEC mode.
show mmrp-flood-optimization [summary| mad [pw neighbor pw-id]| statistics [pw neighbor pw-id]|
registrations [received] [core-bridge bridge-domain-name:group-name] [isid isid]]
Syntax Description
Displays the summary of the current timer
values, total number of core bridges,
pseudowires, I-SIDs configured,
declarations, and registrations.
summary
Displays the current state of the MRP
Attribute Declaration (MAD) component on
a pseudowire, for each active attribute value
(that is, group B-MAC).
mad
Indicates the pseudowire.pw
Indicates the IP address of the neighbor.
neighbor
Indicates the pseudowire ID.
pw-id
Displays the packet statistics per pseudowire.statistics
Displays the I-SIDs that are declared and a
list of peers that have made registrations for
those I-SIDs
registrations
Displays all the I-SIDs where registrations
have been received, even if those I-SIDs are
not configured locally.
received
Displays the information about a specific
core-bridge.
core-bridge
Core bridge domain name.
bridge-domain-name
Group name.
group-name
Displays information of a specific service
instance identifier.
isid
Service instance identifier.
isid
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
454
Provider Backbone Bridge Commands
show mmrp-flood-optimization
To Next Page
Loading...
Need help?
General
