type (VPLS)
To configure the type for MAC address aging, use the type command in L2VPN bridge group bridge domain
MAC aging configuration mode. To disable this feature, use the no form of this command.
type {absolute| inactivity}
no type {absolute| inactivity}
Syntax Description
Configures the absolute aging type.absolute
Configures the inactivity aging type.inactivity
Command Default
By default, the inactivity type is configured.
Command Modes
L2VPN bridge group bridge domain MAC aging configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
In general, the type is set to inactivity. With an inactivity type configuration, a MAC address is removed from
the forwarding table after the MAC address is inactive for the configured aging time.
With an absolute type configuration, a MAC address is always removed from the forwarding table after the
aging time has elapsed once it is initially learned.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to configure the MAC address aging type to absolute for every member
of the bridge domain named bar:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
378
Multipoint Layer 2 Services Commands
type (VPLS)
To Next Page
Loading...
Need help?
General
