service-carving
To specify a list of service identifiers as active and standby services, use the service-carving command in
the EVPN Interface Ethernet segment configuration mode. To delete service carving of a list of service
identifiers, use the no form of this command.
service-carving manual[primary service-id -range secondary service-id-range]
no service-carving manual[primary service-id-range secondary service-id-range]
Syntax Description
Specifies service identifiers or EVI-list services manually.manual
Specifies the primary services list.primary
Specifies the secondary services list.secondary
Specifies the services list notation in the range 100, 201-300, 401. The
range is within 256 to 16777214.
service-id-range
Command Default
Automatic service carving
Command Modes
EVPN interface Ethernet segment configuration mode
Command History
ModificationRelease
This command was introduced.Release 4.3.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to specify a list of service identifiers as active and standby services:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# evpn
RP/0/RSP0/CPU0:router(config-evpn)# interface bundle-ether 1
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
431
Provider Backbone Bridge Commands
service-carving
To Next Page
Loading...
Need help?
General
