debug ethernet mvrp protocol
To enable MVRP protocol debugging on a specific interface, location or vlan, use the debug ethernet mvrp
protocol command in the EXEC mode. To disable debugging, use the no form of this command.
debug ethernet mvrp protocol [vlan vlan-id] [interface interface-name| location node-id]
no debug ethernet mvrp protocol [vlan vlan-id] [interface interface-name| location node-id]
Syntax Description
{Optional} Specific vlan-id to filter on.
vlan vlan-id
{Optional} Filters by interface.
Physical interface or a virtual interface.
Use the show interfaces command to see a list of all possible interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
interface interface-name
(Optional) Indicates the location. The node-id argument is entered in the
rack/slot/module notation.
location node-id
Command Default
By default, debug is enabled for all vlans, interfaces, and locations.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readethernet-services
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
477
Multiple Spanning Tree Protocol Commands
debug ethernet mvrp protocol
To Next Page
Loading...
Need help?
General
