monitor interface (port0)
To specify a port to detect a ring link failure, use the monitor interface command in g8032 port0 submode.
To delete the port, use the no form of this command.
monitor interface interface-name
no monitor interface interface-name
Syntax Description
Name of the monitored interface. The monitored interface must be a
sub-interface of the main interface.
interface-name
Command Default
Configured physical Ethernet or Ether Bundle interface
Command Modes
Ethernet ring g8032 port0 submode
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows the output from the monitor interface command:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# ethernet ring g8032 g1
RP/0/RSP0/CPU0:router(config-l2vpn-erp)# port0 interface TenGigE 0/4/0/0
RP/0/RSP0/CPU0:router(config-l2vpn-erp-port0)# monitor interface GigabitEthernet 0/0/1/0
RP/0/RSP0/CPU0:router(config-l2vpn-erp-port0)#
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
283
Multipoint Layer 2 Services Commands
monitor interface (port0)
To Next Page
Loading...
Need help?
General
