Cisco A9K-SIP-700 Reference Guide

interface (PVRST)
To enable and configure Per VLAN Rapid Spanning Tree (PVRST) on an interface, use the interface command
in PVRST configuration mode. To disable PVRST, use the no form of this command.
interface {Bundle-Ether| FastEthernet| FortyGigE| GigabitEthernet| HundredGigE| TenGigE}[guard|
hello-time| link-type| portfast| vlan]
no interface {Bundle-Eher| FastEthernet| FortyGigE| GigabitEthernet| HundredGigE| TenGigE}[guard|
hello-time| link-type| portfast| vlan]
Syntax Description
Specifies Aggregated Ethernet interface.Bundle-Ether
Specifies FastEthernet/IEEE 802.3 interface.FastEthernet
Specifies FortyGigabitEthernet or IEEE 802.3 interface.FortyGigE
Specifies GigabitEthernet or IEEE 802.3 interface.GigabitEthernet
Specifies HundredGigabitEthernet or IEEE 802.3 interface.HundredGigE
Specifies TenGigabitEthernet or IEEE 802.3 interface.TenGigE
Specifies bridge guard features.guard
Specifies Hello-Time interface.hello-time
Specifies the link type of an interface.link-type
Specifies Portfast for an interface.portfast
Specifies VLAN configuration for an interface.vlan
Command Default
None
Command Modes
PVRST configuration
Command History
ModificationRelease
This command was introduced.Release 5.1
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
527
Multiple Spanning Tree Protocol Commands
interface (PVRST)

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English