exclusion list
To define a set of Virtual LAN (VLAN) IDs that are not protected by the Ethernet ring protection mechanism,
use the exclusion list command in Ethernet ring g8032 configuration submode. To delete the set of VLAN
IDs, use the no form of this command.
exclusion list vlan-ids vlan range
no exclusion list vlan-ids vlan range
Syntax Description
Specifies a list of VLANs. Ranges in the form a-b,c,d,e-f,g where VLAN value is 1–4094
and/or untagged.
By default, all the VLANs configured under ring ports are blocked. VLAN IDs specified
here cannot belong to the inclusion-list. VLAN IDs range cannot overlap with the IDs
specified under inclusion-list.
vlan-ids
Command Default
Configured physical Ethernet or ether bundle interface
Command Modes
Ethernet ring g8032 configuration submode
Command History
ModificationRelease
This command was introduced.Release 4.1.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows the output from the exclusion list command:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# ethernet ring g8032 r1
RP/0/RSP0/CPU0:router(config-l2vpn-erp)# exclusion-list vlan-ids e-g
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
255
Multipoint Layer 2 Services Commands
exclusion list
To Next Page
Loading...
Need help?
General
