show l2vpn pwhe
To display the pseudowire headend (PWHE) information, use the show l2vpn pwhe command in EXEC
mode.
show l2vpn pwhe {detail| interface| summary}
Syntax Description
Specifies the details of the interface.detail
Specifies the name of the interface.interface
Specifies the summary information of the interface.summary
Command Default
None
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
readl2vpn
Examples
This example show the sample output for show l2vpn pwhe detail command:
RP/0/RSP0/CPU0:router# show l2vpn pwhe detail
Interface: PW-Ether1 Interface State: Down, Admin state: Up
Interface handle 0x20000070
MTU: 1514
BW: 10000 Kbit
Interface MAC addresses: 0279.96e9.8205
Label: 16000
L2-overhead: 0
VC-type: 5
CW: N
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
197
Point to Point Layer 2 Services Commands
show l2vpn pwhe
To Next Page
Loading...
Need help?
General
