Cisco A9K-SIP-700 Reference Guide

l2transport l2protocol
To configure Layer 2 protocol handling, use the l2transport l2protocol command in interface configuration
mode. To return to the default behavior, use the no form of this command.
l2transport l2protocol cpsv {reverse-tunnel| tunnel}
no l2transport l2protocol cpsv {reverse-tunnel| tunnel}
Syntax Description
Enables L2PT for the interface. L2PT is enabled for the following protocols only:
•
CDP
•
STP
•
VTP
STP includes all Spanning Tree protocol derivatives (RSTP, MSTP,
etc.)
Note
cpsv
Performs L2PT encapsulation on frames as they enter the interface. Also, performs L2PT
de-encapsulation on frames as they exit they interface.
L2PT encapsulation rewrites the destination MAC address with the L2PT destination
MAC address. L2PT deencapsulation replaces the L2PT destination MAC address with
the original destination MAC address.
tunnel
Performs L2PT encapsulation on frames as they exit the interface. Also, perform L2PT
deencapsulation on frames as they enter the interface.
reverse-tunnel
Command Default
None
Command Modes
Interface configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
These L2 protocols are available:
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
94
Point to Point Layer 2 Services Commands
l2transport l2protocol

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English