leave-time
To set the leave time for all active ports, use the leave-time command in the MVRP configuration mode. To
return to the default value, use the no form of this command.
leave-time interval
no leave-time interval
Syntax Description
Minimum time, in seconds, for the leaveall timer parameter for all active ports. The
range is from 1 to 90 seconds .
interval
Command Default
The default is 30 seconds.
Command Modes
MVRP configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writeethernet-services
Examples
The following example shows how to configure the join time for active ports:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# spanning-tree mst AA
RP/0/RSP0/CPU0:router(config-mstp)# mvrp static
RP/0/RSP0/CPU0:router(config-mvrp)# periodic transmit interval 5
RP/0/RSP0/CPU0:router(config-mvrp)# leave-time 30!
Related Commands
DescriptionCommand
Enables debugging of sent and received MVRP packets.debug ethernet mvrp packets, on page 475
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
533
Multiple Spanning Tree Protocol Commands
leave-time
To Next Page
Loading...
Need help?
General
