debug spanning-tree packet raw
To enable debugging raw packet output for all received packets or sent packets, use the debug spanning-tree
packet raw command in EXEC mode. To disable debugging, use the no form of this command.
debug spanning-tree packet raw {sent| received} [interface interface-name]
no debug spanning-tree packet raw {sent| received} [interface interface-name]
Syntax Description
Display packets being received.received
Display packets being sent.sent
{Optional} Filters by interface.
Physical interface or a virtual interface.
Use the show interfaces command to see a list of all possible interfaces
currently configured on the router.
Note
For more information about the syntax for the router, use the question mark (?)
online help function.
interface interface-name
Command Default
If an interface is not specified, debug is enabled for all interfaces.
Command Modes
EXEC
Command History
ModificationRelease
This command was introduced.Release 4.0.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
This command enables raw packet debug for all STP protocols: MSTP, MSTAG, REPAG, PVSTAG and
PVRSTAG.
Task ID
OperationsTask ID
readinterface
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
485
Multiple Spanning Tree Protocol Commands
debug spanning-tree packet raw
To Next Page
Loading...
Need help?
General
