port-down flush disable (VPLS)
To disable MAC flush when the bridge port is nonfunctional, use the port-down flush disable command in
the L2VPN bridge group bridge domain MAC configuration mode. Use the no form of this command to
enable the MAC flush when the bridge port is nonfunctional.
port-down flush disable
no port-down flush disable
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
L2VPN bridge group bridge domain MAC configuration
Command History
ModificationRelease
This command was introduced.Release 3.9.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The port-down flush disable command disables the MAC flush when the bridge port is nonfunctional.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to disable MAC flush when the bridge port is nonfunctional:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# mac
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac)# port-down flush disable
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
302
Multipoint Layer 2 Services Commands
port-down flush disable (VPLS)
To Next Page
Loading...
Need help?
General
