Related Commands
DescriptionCommand
Configures bridge behavior when the number of learned MAC
addresses reaches the MAC limit configured.
action (VPLS), on page 232
Establishes a bridge domain, and enters L2VPN bridge group bridge
domain configuration mode.
bridge-domain (VPLS), on page 240
Creates a bridge group so that it can contain bridge domains and then
to assign network interfaces to the bridge domain.
bridge group (VPLS), on page 242
Enters L2VPN configuration mode.l2vpn, on page 100
Enters L2VPN bridge group bridge domain MAC configuration mode.mac (VPLS), on page 277
Configures the specified action when the number of MAC addresses
learned on a bridge is reached.
maximum (VPLS), on page 281
Specifies the type of notification that is sent when the number of
learned MAC addresses exceeds the configured limit.
notification (VPLS), on page 295
Cisco ASR 9000 Series Aggregation Services Router VPN and Ethernet Services Command Reference, Release
6.1.x
303
Multipoint Layer 2 Services Commands
port-down flush disable (VPLS)
To Next Page
Loading...
Need help?
General
